HP E4510-48G, Command Reference Manual

Page: 194 / 1334

6-15
configuration to the aggregate interface and its aggregation member ports. If the system fails to do
that on the aggregate interface, it stops applying the configuration to the aggregation member
ports. If it fails to do that on an aggregation member port, it simply skips the port and moves to the
next port. For information about Layer-2 aggregate interfaces, refer to Link Aggregation
Configuration in the Access Volume .
To change the link type of a port from trunk to hybrid or vice versa, you must set the link type to access
first.
Examples
# Configure GigabitEthernet 1/0/1 as a trunk port.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
# Configure all the ports in the manual port group group1 as hybrid ports.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] group-member gigabitethernet 1/0/2
[Sysname-port-group-manual-group1] group-member gigabitethernet 1/0/3
[Sysname-port-group-manual-group1] port link-type hybrid
# Configure Layer-2 aggregate interface Bridge-aggregation 1 and its member ports as hybrid ports.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type hybrid
port trunk permit vlan
Syntax
port trunk permit vlan { vlan-id-list | all }
undo port trunk permit vlan { vlan-id-list | all }
View
Ethernet interface view, port group view, Layer-2 aggregate interface view
Default Level
2: System level
Parameters
vlan-id-list : VLANs that the trunk port(s) will be assigned to. This argument is expressed in the format
of [ vlan-id1 [ to vlan-id2 ] ]&<1-10>, where vlan-id ranges from 1 to 4094 and &<1-10> indicates that
you can specify up to 10 VLAN IDs or VLAN ID ranges.