HP E4510-48G, Command Reference Manual

Page: 1270 / 1334

20-6
Examples
# Configure the time that a receiving device should keep the NDP packets as 60 seconds.
<Sysname> system-view
[Sysname] ndp timer aging 60
ndp timer hello
Syntax
ndp timer hello hello-time
undo ndp timer hello
View
System view
Default Level
2: System level
Parameters
hello-time : Interval to send NDP packets, in the range 5 to 254 seconds.
Description
Use the ndp timer hello command to set the interval to send NDP packets.
Use the undo ndp timer hello command to restore the default.
By default, the interval to send NDP packets is 60 seconds.
Note that the interval for sending NDP packets cannot be longer than the time for the receiving device
to hold NDP packets; otherwise, the NDP table may become instable.
Related commands: ndp timer aging .
Examples
# Set the interval to send NDP packets to 80 seconds.
<Sysname> system-view
[Sysname] ndp timer hello 80
reset ndp statistics
Syntax
reset ndp statistics [ interface interface-list ]
View
User view
Default Level
2: System level