HP E4510-48G, Command Reference Manual

Page: 1265 / 1334

20-1
20
Cluster Management Configuration Commands
NDP Configuration Commands
display ndp
Syntax
display ndp [ interface interface-list ]
View
Any view
Default Level
1: Monitor level
Parameters
interface interface-list : Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list argument is in the format of interface-list = { interface-type interface-number [ to
interface-type interface-number ] } & <1-10>,where, interface-type is port type and interface-number is
port number, and &<1-10> means that you can provide up to 10 port indexes/port index lists for this
argument.
Description
Use the display ndp command to display NDP configuration information, which includes the interval to
send NDP packets, the time for the receiving device to hold NDP information and the information about
the neighbors of all ports.
Examples
# Display NDP configuration information.
<Sysname> display ndp
Neighbor Discovery Protocol is enabled.
Neighbor Discovery Protocol Ver: 1, Hello Timer: 60(s), Aging Timer: 180(s)
Interface: GigabitEthernet1/0/1
Status: Enabled, Pkts Snd: 0, Pkts Rvd: 0, Pkts Err: 0
Interface: GigabitEthernet1/0/2
Status: Enabled, Pkts Snd: 0, Pkts Rvd: 0, Pkts Err: 0
Interface: GigabitEthernet1/0/3
Status: Enabled, Pkts Snd: 0, Pkts Rvd: 0, Pkts Err: 0
Interface: GigabitEthernet1/0/4
Status: Enabled, Pkts Snd: 28440, Pkts Rvd: 27347, Pkts Err: 0