16-15
Description
Use the
info-center snmp channel
command to configure the channel to output system information
to the SNMP module.
Use the
undo info-center snmp channel
command to restore the default channel to output system
information to the SNMP module.
By default, output of system information to the SNMP module is enabled with a default channel name
of snmpagent and a default channel number of 5.
For more information, refer to the
display snmp-agent
command in the
SNMP Commands
in the
System Volume
.
Examples
# Output system information to the SNMP module through channel 6.
<Sysname> system-view
[Sysname] info-center snmp channel 6
info-center source
Syntax
info-center source
{
module
-
name
|
default
}
channel
{
channel
-
number | channel
-
name
} [
debug
{
level
severity
|
state
state
} * |
log
{
level
severity
|
state
state
} * |
trap
{
level
severity
|
state
state
}
* ] *
undo info-center source
{
module
-
name
|
default
}
channel
{
channel
-
number | channel
-
name
}
View
System view
Default Level
2: System level
Parameters
module
-
name
: Specifies the output rules of the system information of the specified modules. For
instance, if information on ARP module is to be output, you can configure this argument as ARP. You
can use the
info-center source ?
command to view the modules supported by the device.
default
: Specifies the output rules of the system information of all the modules allowed to output the
system information, including all the modules displayed by using the
info-center source ?
command.
debug
: Debugging information.
log
: Log information.
trap
: Trap information.
level severity
: Specifies the severity of system information, refer to
for details. With this
keyword, you can specify the severity level of the information allowed/denied to output.
state state
: Configures whether to output the system information, which could be
on
(enabled) or
off
(disabled). With this keyword, you can specify whether to output the specified system information.
channel
-
number
: Specifies a channel number, in the range 0 to 9.
Summary of Contents for E4510-48G
