15-9
Parameters
all
: All debugging functions.
timeout time
: Specifies the timeout time for the
debugging all
command. When all debugging is
enabled, the system automatically executes the
undo debugging all
command after the
time.
The
value ranges from 1 to 1440, in minutes.
module-name
: Module name, such as arp or device. You can use the
debugging ?
command to
display the current module name.
option
: The debugging option for a specific module. Different modules have different debugging
options in terms of their number and content. You can use the
debugging module-name ?
command
to display the currently supported options.
Description
Use the
debugging
command to enable the debugging of a specific module.
Use the
undo debugging
command to disable the debugging of a specific module.
By default, debugging functions of all modules are disabled.
Note the following:
z
Output of the debugging information may degrade system efficiency, so you are recommended to
enable the debugging of a specific module for diagnosing network failure, and not to enable the
debugging of multiple modules at the same time.
z
Default Level
describes the default level of the
debugging all
command. Different
debugging
commands may have different default levels.
z
You must configure the
debugging
,
terminal debugging
and
terminal monitor
commands first
to display detailed debugging information on the terminal. For the detailed description on the
terminal debugging
and
terminal monitor
commands, refer to
Information Center Commands
in
the
System Volume
.
Related commands:
display debugging
.
Examples
# Enable IP packet debugging.
<Sysname> debugging ip packet
display debugging
Syntax
display
debugging
[
interface
interface-type interface-number
]
[
module-name
]
View
Any view
Default Level
1: Monitor level
Parameters
interface interface-type interface-number
: Displays the debugging settings of the specified interface,
where
interface-type interface-number
represents the interface type and number.
Summary of Contents for E4510-48G
