HP E4510-48G, Command Reference Manual

Page: 113 / 1334

4-1
4
MSTP Configuration Commands
MSTP Configuration Commands
active region-configuration
Syntax
active region-configuration
View
MST region view
Default Level
2: System level
Parameters
None
Description
Use the active region-configuration command to activate your MST region configuration.
Note that:
z
The configuration of MST region–related parameters, especially the VLAN-to-instance mapping
table, will cause MSTP to launch a new spanning tree calculation process, which may result in
network topology instability. To reduce the possibility of topology instability caused by
configuration, MSTP will not immediately launch a new spanning tree calculation process when
processing MST region–related configurations; instead, such configurations will take effect only
after you activate the MST region–related parameters using this command, or enable MSTP using
the stp enable command in the case that MSTP is not enabled.
z
Before running this command, you are recommended to use the check region-configuration
command to check whether the MST region configurations to be activated are correct. You should
run this command only if the result returns positive.
Related commands: instance , region-name , revision-level , vlan-mapping modulo , check
region-configuration .
Examples
# Map VLAN 2 to MSTI 1 and activate MST region configuration manually.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] instance 1 vlan 2
[Sysname-mst-region] active region-configuration