HP E4510-48G, Command Reference Manual

Page: 1106 / 1334

9-4
Note that enabling of the HTTPS service triggers an SSL handshake negotiation process. During the
process, if a local certificate of the device already exists, the SSL negotiation is successfully performed,
and the HTTPS service can be started normally. If no local certificate exists, a certificate application
process will be triggered by the SSL negotiation. Since the application process takes much time, the
SSL negotiation often fails and the HTTPS service cannot be started normally. Therefore, the ip https
enable command must be executed for multiple times to ensure normal startup of the HTTPS service.
Examples
# Enable the HTTPS service.
<Sysname> system-view
[Sysname] ip https enable
ip https port
Syntax
ip https port port-number
undo ip https port
View
System view
Default Level
3: Manage level
Parameters
port-number : Port number of the HTTPS service, in the range 1 to 65535.
Description
Use the ip https port command to configure the port number of the HTTPS service.
Use the undo ip https port command to restore the default.
By default, the port number of the HTTPS service is 443.
Note that this command does not check whether the configured port number conflicts with that of an
existing service. Therefore, you must ensure that the port number is not used by another service
before the configuration.
Examples
# Configure the port number of the HTTPS service as 6000.
<Sysname> system-view
[Sysname] ip https port 6000
ip https ssl-server-policy
Syntax
ip https ssl-server-policy policy-name
undo ip https ssl-server-policy