HP E4510-48G, Command Reference Manual

Page: 1032 / 1334

4-30
z
After you execute the above command, the device will prompt you to confirm the configuration.
You must enter <Y> or <y> to make the configuration take effect. The original configuration will be
overwritten at the same time.
z
If you use the clock command after the schedule reboot delay command to adjust the system
time, the reboot wait time set by the schedule reboot delay command will become invalid.
z
If you are performing file operations when the device is to be rebooted, the system does not
execute the command for the sake of security.
This command reboots the device after the specified delay time, thus resulting in service interruption.
Please use it with caution.
Examples
# Configure the device to reboot in 88 minutes (supposing the current time is 11:48).
<Sysname> schedule reboot delay 88
Reboot system at 13:16 06/06/2006(in 1 hour(s) and 28 minute(s)). confirm? [Y/N]:
# If you have used the terminal logging command to enable the log display function on the terminal
before setting a reboot time, the system will automatically display related log information after you
enter y. By default, the log display function is enabled on the terminal.
<Sysname>
%Jun 6 11:48:44:860 2006 Sysname CMD/4/REBOOT:
vty0(192.168.1.54): Set schedule reboot parameters at 11:48:44 06/06/2006, and system will
reboot at 13:16 06/06/2006.
shutdown-interval
Syntax
shutdown-interval time
undo shutdown-interval
View
System view
Default Level
2: System level
Parameters
time : Detection interval in seconds, in the range of 1 to 300.
Description
Use the shutdown-interval command to set a detection interval.
Use the undo shutdown-interval command to restore the default.