HP E3800 Series, Access Security Manual

Page: 629 / 732

13-57
Configuring Port-Based and User-Based Access Control (802.1X)
Displaying 802.1X Configuration, Statistics, and Counters
Figure 13-11.Example of show port-access authenticator Command
The information displayed with the
show port-access authenticator
command
for individual (config | statistics | session-counters | vlan | clients) options is
described below.
HP Switch(config)# show port-access authenticator
Port Access Authenticator Status
Port-access authenticator activated [No] : Yes
Allow RADIUS-assigned dynamic (GVRP) VLANs [No] : Yes
Auth Unauth Untagged Tagged Kbps In RADIUS Cntrl
Port Clients Clients VLAN VLANs Port COS Limit ACL Dir
---- ------- -------- -------- ------ --------- ----------- ------ -----
1 1 1 4006 Yes 77777777 500000 Yes both
2 2 0 MACbased No No 500000 Yes both
3 4 0 1 Yes No 1000000 No both
...
Syntax: show port-access authenticator config [ port-list ]
Displays 802.1X port-access authenticator configuration
settings, including:
• Whether port-access authentication is enabled
• Whether RADIUS-assigned dynamic VLANs are supported
• 802.1X configuration of ports that are enabled as 802.1X
authenticators (For a description of each setting, refer to
the syntax descriptions in “2. Reconfigure Settings for
Port-Access” on page 13-21. Use the
show running
command to view the current
client-limit
configuration
available for switches.)
You can display 802.1X port-access authenticator
configuration for all switch ports or specified ports.
802.1X configuration information for ports that are not
enabled as 802.1X authenticators is not displayed.