HP E3800 Series, Access Security Manual

Page: 588 / 732

13-16
Configuring Port-Based and User-Based Access Control (802.1X)
General Setup Procedure for 802.1X Access Control
Overview: Configuring 802.1X Authentication on the
Switch
This section outlines the steps for configuring 802.1X on the switch. For
detailed information on each step, refer to the following:
■ “802.1X User-Based Access Control” on page 13-3
■ “802.1X Port-Based Access Control” on page 13-3
■ “Configuring Switch Ports To Operate As Supplicants for 802.1X Connec-
tions to Other Switches” on page 13-51.
1. Enable 802.1X user-based or port-based authentication on the individual
ports you want to serve as authenticators. On the ports you will use as
authenticators, either accept the default 802.1X settings or change them,
as necessary. Note that, by default, the port-control parameter is set to
auto
for all ports on the switch. This requires a client to support 802.1X
authentication and to provide valid credentials to get network access.
Refer to page 13-18.
2. If you want to provide a path for clients without 802.1X supplicant
software to download the software so that they can initiate an authenti-
cation session, enable the 802.1X Open VLAN mode on the ports you want
to support this feature. Refer to page 13-32.
3. Configure the 802.1X authentication type. Options include:
• Local Operator username and password (using the password
port-access command).
• EAP RADIUS: This option requires your RADIUS server application
to support EAP authentication for 802.1X.
• CHAP (MD5) RADIUS: This option requires your RADIUS server
application to support CHAP (MD5) authentication.
Refer to page 13-24.
4. If you select either
eap-radius
or
chap-radius
for step 3, use the
radius host
command to configure up to three RADIUS server IP address(es) on the
switch. See page 13-25.
5. Enable 802.1X authentication on the switch. Refer to “1. Enable 802.1X
Authentication on Selected Ports” on page 13-18.
6. Test both the authorized and unauthorized access to your system to
ensure that the 802.1X authentication works properly on the ports you
have configured for port-access.