Turning on the monitor
1.
Press the Power button on the computer to turn it on.
2.
Press the Power button on the front of the monitor to turn it on.
CAUTION:
Burn-in image damage may occur on monitors that display the same static image on the screen
for 12 or more consecutive hours of nonuse. To avoid burn-in image damage on the monitor screen, you
should always activate a screen saver application or turn off the monitor when it is not in use for a prolonged
period of time. Image retention is a condition that may occur on all LCD screens. Monitors with a “burned-in
image” are not covered under the HP warranty.
NOTE:
If pressing the Power button has no effect, the Power Button Lockout feature may be enabled. To
disable this feature, press and hold the monitor Power button for 10 seconds.
NOTE:
You can disable the power LED in the OSD menu. Press the Menu button on the front of the monitor,
and then select
Power Control
>
Power LED
>
Off
.
When the monitor is powered on, a Monitor Status message is displayed for five seconds. The message
shows which input is the current active signal, the status of the auto-switch source setting (On or Off; default
setting is On), the current preset screen resolution, and the recommended preset screen resolution.
The monitor automatically scans the signal inputs for an active input and uses that input for the screen.
Setting up the monitor
11
Summary of Contents for E202
Page 1: ...User Guide ...
Page 4: ...iv About This Guide ...
