CLI commands
Switch port context
2-183
ingress rate
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
ingress rate
<(128k|256k|512k|1m|2m|4m|8m|16m|32m)>
Set the maximum rate at which this port will accept ingress traffic.
use ingress rate
Limit the ingress data rate.
no use ingress rate
Do not limit the ingress data rate.
ingress traffic type
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
ingress traffic type (broadcast | mubroadcast | all)
Select the type of traffic to which rate limiting applies.
loop protection
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
loop protection
Enables loop protection on this port.
no loop protection
Disables loop protection on this port.
mac authentication
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
mac authentication
Enables support for MAC-based authentication.
no mac authentication
Disables support for MAC-based authentication.
mac filter list
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
mac filter list
<name>
Accept the MAC addresses defined in the specified list.
no mac filter list
<name>
Remove this list of MAC ranges.
poe-class-support
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
poe-class-support (class1-2 | class0-3)
Set the Power over Ethernet limit.
Summary of Contents for E-MSM720
