HP E-MSM720, Reference Manual

Page: 221 / 244

CLI commands
Wireless interface context
2-171
If you have installed multiple controllers, reducing the receiver sensitivity of the controller from
its maximum will help to reduce the amount of crosstalk between the wireless stations to better
support roaming clients. By reducing the receiver sensitivity, client stations will be more likely to
connect with the nearest access point.
transmit power
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
transmit power (DB | max)
Sets the maximum transmission power of the wireless radio.
Parameters
<db>
Power is specified in steps of 1dBm. The maximum setting is 18 dBm.
Note: The actual transmit power used may less than the value specified. The controller determines
the power to used based on the settings you made for regulatory domain, wireless mode, and
operating frequency.
multicast rate
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
multicast rate (1 | 2 | 5.5 | 6 | 9 | 11 | 12 | 18 | 24 | 36 | 48 | 54)
Sets the transmit rate for multicast traffic.
This is a fixed rate, which means that if a station is too far away to receive traffic at this rate, then
the multicast will not be seen by the station. By rasing the multicast rate you can increase overall
throughput significantly.
dot11 automatic frequency
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
dot11 automatic frequency
Enable this option to have the controller automatically determine the best operating frequency.
no dot11 automatic frequency
Disable automatic frequency selection.
dot11 automatic frequency period
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
dot11 automatic frequency period (disabled | 1h | 2h | 4h | 8h | 12h | 24h)
Specify how often the frequency setting is re-evaluated when automatic frequency selection is
enabled.
dot11 automatic frequency time
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
dot11 automatic frequency time <time>
Specify when the channel should be re-evaluated.