HP E-MSM720, Reference Manual, Page: 149 / 244

CLI commands
Virtual AP context
2-99
Virtual AP context
Path: View > Enable > Config > Virtual AP
Use this context to configure VSC profiles (formerly called VAPs).
By default, one VSC profile exists with the name "HP". This is the default profile and cannot be
deleted.
virtual ap name
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
virtual ap name <name>
Change the VAP (VSC) name.
access control
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
access control
Sets this profile to use the services of the controller’s access control mechanism for
authentication and control of client sessions.
no access control
Do not provide access control with this VAC (VAP).
When enabled
„ The controller provides a variety of methods for user authentication, including: MAC, 802.1X,
and HTML via either the local user list or a RADIUS server.
„ Egress traffic can be routed based on the user state: authenticated, unauthenticated, or
intercepted.
When disabled
„
The controller does not perform user authentication, either via RADIUS or the local user list.
All authentication must be handled by a remote device.
„
All wireless traffic is bridged to an egress VLAN.
„ No access controller functions are available. This means no support for RADIUS attributes for
the controller.
„ 802.1X support is available, including support for RADIUS attributes for users.
force centralize data
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
force centralize data
Force use of the client data tunnel even when the AP is L2 connected to the controller.
no force centralize data
Automatically determine if the client data tunnel is required.