-241
Installing the TC Amp board
1. Align the TC Amp board with the mounting holes.
2. Using a
1
⁄
4
” nut driver or standard screwdriver, reinstall the 3 mounting
screws.
3. Reconnect the model and support thermocouple wires.
4. Reconnect the umbilical cable.
5. Reinstall the right side access panel.
6. Reinstall the side panels. See
“Installing the side panels” on page 164
7. Reinstall the top panel. See
“Installing the top panel” on page 162
Umbilical Hose
Required Tools
•
5
⁄
16
” nut driver or standard screwdriver
•
1
⁄
4
” nut driver
•
5
⁄
32
” allen wrench
• Cutters
Hardware
• Wire tie
• 10-32 x
3
⁄
8
” slotted screws (x7)
•
1
⁄
4
- 20 x
1
⁄
2
” button head cap screws (x2)
Removing the umbilical hose
1. Remove the top panel. See
“Removing the top panel” on page 161
2. Remove the side panels. See
“Removing the side panels” on page 162
3. Remove the upper electronics bay cover. See
tronics bay cover” on page 173
4. Using a
5
⁄
16
” nut driver or standard screwdriver, remove the right side
access panel mounting screws and remove the panel. See
Summary of Contents for DESIGNJET 3D
