HP Converged Architecture 700, Deployment Manual

Page: 71 / 111

Maximum
Bandwidth
(Gb) Preferred
Bandwidth
(Gb) Purpose VLAN ID VLAN Type Name
20 2 Fault toler-
ance <<compute_ft_net_vlan>> Tagged Ethernet FT_B
20 9 General <<vm_produc-
tion_net_1_vlan>> Tagged Ethernet VM_Traffic_A
20 9 General <<vm_produc-
tion_net_1_vlan>> Tagged Ethernet VM_Traffic_B
4 Create additional Ethernet networks as needed.
5 Use the information in the following table to create SAN networks.
Table 9: HPE-recommended Fibre Channel networks for fabric-attached networks
Maximum
Bandwidth
(Gb) Preferred
Bandwidth
(Gb) VLAN ID Associate with SAN Type Name
20 8 <<fcoe_san_a_vlan>> VSAN
<<net_fcoe_vsan_a_id>> FCoE SAN_A
20 8 <<fcoe_san_b_vlan>> VSAN
<<net_fcoe_vsan_b_id>> FCoE SAN_B
6 Create additional SAN networks as needed.
7 If additional networks are not required, click Cancel in the Create Network window.
Create Network Sets
Procedure
1 From the top left corner of the HPE OneView UI, choose HP OneView > Network Sets.
2 Click Create network set to create the Mgmt_Set_A network set:
a Name: Mgmt_Set_A.
b Preferred Bandwidth: 1 Gb/s.
c Maximum Bandwidth: 20 Gb/s.
d Click Add networks and add the following networks to this network set:
Tip You can hold the Ctrl key to select multiple networks at one time.
• Mgmt_A
• Deployment_A
• Any additional management networks that you have created for side A
e Select the Untagged checkbox for the Deployment_A network.
3 Click to create the Mgmt_Set_B network set:
a Name: Mgmt_Set_B.
b Preferred Bandwidth: 1 Gb/s.
c Maximum Bandwidth: 20 Gb/s.
d Click Add networks and add the following networks to this network set:
• Mgmt_B
71 Copyright
©
2017 by Nimble Storage, Inc. All rights reserved.
Documentation Feedback
Create Network Sets