Installing a 3.5-inch Hard Drive into an Internal Drive Bay
CAUTION:
To prevent loss of work and damage to the computer or drive:
If you are inserting or removing a hard drive, shut down the operating system properly, then turn off the
computer. Do not remove a hard drive while the computer is on or in standby mode.
Before handling a drive, ensure that you are discharged of static electricity. While handling a drive, avoid
touching the connector. Refer to
Electrostatic Discharge Information on page 53
for more information
about preventing electrostatic damage.
Handle a drive carefully; do not drop it.
Do not use excessive force when inserting a drive.
Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields
such as monitors or speakers.
1.
Prepare the computer for disassembly (
Preparation for Disassembly on page 60
2.
Remove the computer access panel (
Computer Access Panel on page 64
3.
Remove the front bezel (
).
4.
Disconnect the power (1) and data (2) cables from the back of the drive.
NOTE:
The right-angle data cable must be used for this chassis model when installing hard drives
in the 3.5-inch bays to prevent cable damage from overflexing.
5.
Remove the hard drive SATA cable from the top of the fan shroud.
80
Chapter 7 Removal and Replacement Procedures Convertible Minitower (CMT) Chassis