HP BladeSystem bc2000 - Blade PC, Reference Manual, Page: 206 / 434

15-4 www.hp.com HP PC Blade Switch CLI Reference Guide
PHY Diagnostics Commands
show fiber-ports optical-transceiver
The show fiber-ports optical-transceiver Privileged EXEC command displays the optical
transceiver diagnostics.
Syntax
show fiber-ports optical-transceiver [ interface ] [ detailed ]
Parameters
n
interface — A valid Ethernet port. (Full syntax: port )
n
detailed — Detailed diagnostics.
Default Setting
This command has no default configuration.
Command Mode
Privileged EXEC mode
Command Usage
To test optical transceivers, ensure a fiber link is present.
Examples
The following commands display the optical transceiver diagnostics.
Console# show fiber-ports optical-transceiver
Power
Port Temp Voltage Current Output Input TX Fault LOS
---- ---- ------- ------- ------ ----- ------- ---
e1 W OK E OK OK OK OK
e2 OK OK OK OK OK E OK
e3 Copper
Temp – Internally measured transceiver temperature.
Voltage - Internally measured supply voltage.
Current – Measured TX bias current.
Output Power – Measured TX output power.
Input Power – Measured RX received power.
Tx Fault – Transmitter fault
LOS – Loss of signal
N/A - Not Available, N/S - Not Supported, W - Warning, E - Error