HP Aruba 7010 Series, Installation Manual, Page: 12 / 28

12
| 7010 Controller
Aruba 7010 Series Controller
| Installation Guide
LCD Panel
The Aruba 7010 controller is equipped with an LCD panel (see Figure 4 on page 10 .) that displays information about
the controller’s status and provides a menu that allows basic operations such as initial setup and reboot. The LCD
panel displays two lines of text with a maximum of 16 characters on each line. When using the LCD panel, the active
line is indicated by an arrow next to the first letter.
The LCD panel is operated using the two navigation buttons to the right of the screen.

Menu : Allows you to navigate through the menus of the LCD panel.

Enter : Confirms and executes the action currently displayed on the LCD panel.
LCD Mode Menu
The LCD mode menu includes four modes as shown in the following table.
Table 8
LCD Panel Mode
LCD Mode Function Displays Description
Boot Displays the boot up status. “Booting ArubaOS... Displays boot status.
LED Displays the mode of the
STATUS LED.
The LED mode menu allows
you to choose what
information is communicated
by the STATUS LEDs on each
port. See Table 5 on page 10
for descriptions of the LED
behavior of each mode.
LED mode: ADM Administrative– Displays whether the port is
administratively enabled or disabled.
LED mode: DPX Duplex– Displays the duplex mode of the
port.
LED mode: POE PoE– Displays if port is taking PoE power or
not.
LED mode: SPD Speed– Displays the speed of the port.
Exit Exits LED menu.
Status Displays the ArubaOS version. OS Version Displays the ArubaOS version.
Exit Exits Status menu.
Maintenance Allows you to execute some
basic operations of the Aruba
7010 controller such as
uploading an image or
rebooting the system.
Upgrade Image [Partition 0
[Y|N] | Partiion 1 [Y|N]]
Allows you to upgrade the software image on
the selected partition from a predefined
location on an attached USB flash device.
Upload config [Y | N] Uploads the controller’s current configuration
to a predefined location on the attached USB
flash device.
Factory Default [Y|N] Allows you to reset the device to factory
default settings.
Media Eject [Y| N] Completes the reading or writing of the
attached USB device.
Reload system [Y|N] Allows you to reboot the device.
Halt system [Y|N] Allows you to halt the device.
Exit Exits Maintenance menu.