Example
Show bandwidth utilization for trunks.
Switch(config)#
show interfaces trunk-utilization
Status and Counters - Port Utilization
Rx Tx
Port | --------------------------- | ---------------------------
| Kbits/sec Pkts/sec Util | Kbits/sec Pkts/sec Util
-------- ---------- ----- + ---------- ---------- --------- -----
Trk1 | 0 0 0 | 0 0 0
Trk2 | 0 0 0 | 0 0 0
Trk10 | 0 0 0 | 0 0 0
Statistic interactions of interface counters
Table 27: Statistic interactions
Interface counters are cleared using the command
clear statistics
. When certain actions are taken to ports
and trunks, the outcome of the
clear
command differs.
Action taken Trigger
Interaction with interface counter
Adding Port
into trunk
CLI/SNMP
• Interface counters for this port will be cleared across all sessions.
• Average rate counters are not cleared.
Removing
Port from
trunk
CLI/SNMP
• Interface counters for this port will be cleared across all sessions.
• Average rate counters are not cleared.
Trunk port
coming Up
CLI enable
• No change in counters.
• Interface counters for this port are not cleared.
• Average rate counters are not cleared. Counters will start from 0 when the
trunk port comes up.
Trunk port
coming Up
Cable connect
• No change in counters.
• Interface counters for this port are not cleared.
• Average rate counters are not cleared. Counters will start from 0 when the
trunk port comes up.
Trunk port
going Down
CLI disable
• Interface counters for this port are not cleared.
• Average rate counters are cleared.
Trunk port
going Down
Cable
disconnect
• Interface counters for this port are not cleared.
• Average rate counters are cleared.
Table Continued
396
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
