DRAFT - HP Confidential - DRAFT
Removal and replacement procedures 115
IMPORTANT:
If the iLO configuration settings are reset to the default values, remote access to the
machine will be lost. Access the physical machine and repeat the procedure described in this
section to re-enable the dedicated iLO management connector.
To enable the dedicated iLO management module:
1.
During the server startup sequence after installing the module, press
F9
in the POST screen.
The System Utilities screen appears.
2.
Select
System Configuration
|
iLO 4 Configuration Utility
.
The iLO 4 Configuration Utility screen appears.
3.
Select
Network Options
, and then press
Enter
.
The Network Options screen appears.
4.
Set the
Network Interface Adapter
field to
ON
, and then press
Enter
.
5.
Press
F10
to save your changes.
A message prompt to confirm the iLO settings reset appears.
6.
Press
Enter
to reboot the iLO settings.
7.
Press
Esc
until the main menu is displayed.
8.
Select
Reboot the System
to exit the utility and resume the boot process.
The IP address of the enabled dedicated iLO connector appears on the POST screen on the subsequent
boot-up. Access the Network Options screen again to view this IP address for later reference.
Power pass-through module
CAUTION:
To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
1.
Power down the server (on page
).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Remove the server from the rack (on page
).
4.
Remove the access panel ("
).
