Remove the chassis access panel
Procedure
1.
.
2.
Disconnect all peripheral cables from the nodes and chassis.
WARNING:
The chassis is very heavy. To reduce the risk of personal injury or damage to the equipment:
• Observe local occupational health and safety requirements and guidelines for manual material
handling.
• Remove all installed components from the chassis before installing or moving the chassis.
• Use caution and get help to lift and stabilize the chassis during installation or removal, especially
when the chassis is not fastened to the rack.
CAUTION:
Before installing the chassis into the rack or removing the chassis from the rack, Hewlett Packard
Enterprise recommends removing the nodes, the drives, and the power supplies. Because a fully
populated chassis is heavy, removing these components facilitates moving the chassis.
3.
Remove all nodes from the chassis
.
4.
5.
.
6.
.
7.
.
8.
Remove the chassis from the rack
9.
Unlock the access panel latch using the T-15 Torx screwdriver and release the access panel latch.
Remove the chassis access panel
45
