Chapter 4
Removing and Replacing Components
SCSI Backplane Board
92
Figure 4-35
SCSI Backplane Removal and Replacement
Removing the SCSI Backplane
To remove the SCSI backplane, perform the following steps:
Step 1. If rack mounted, slide the HP Server out from the rack until it stops. (Refer to the hp9000 rp4440
Installation Guide for additional information.)
Step 2. Remove the front bezel. (Refer to “Front Bezel” on page 38.)
Step 3. Remove the front cover. (Refer to “Front and Top Covers” on page 39.)
Step 4. Remove the memory extender board. (Refer to “Memory Extender Board” on page 45.)
Step 5. Remove the processor extender board. (Refer to “Processor Extender Board” on page 53.)
Step 6. Remove the two hot-plug disk drives. (Refer to “Hot-Plug Disk Drives” on page 88.)
