HP 85106D, Manual

Page: 93 / 244

3-8 HP 85106D mm-Wave System
Performance Verification
Calibration
NOTE
If all of the registers are full, press any cal set key and respond to the
displayed prompts. You delete the original contents of that register, then
store your calibration there.
When the calibration is complete, press the program {
RESUME
} key. The
program resets the HP 8510C for REMOTE operation and returns you to the
System Performance Verification Menu.
Selecting the
Verification Standard
Press {
SELECTION STANDARD
}. The program displays the Verification Kit
Device Selection Menu. Use this “form” menu to select the standard you
want to measure and enter its serial number. Change the averaging factor for
measurement and select the Cal Set register, and to enter any comments.
A complete verification requires that you measure all devices in the kit.
However, you must select the devices one-at-a-time from the Verify
Standard menu. Select NO for the 45 MHz measurement and verify that the
other selections are correct.
1. Press {
DONE
} after the form is completed. Insert the Verification Kit disk
into the HP 8510 disk drive and press{
RESUME
}. The program reads the
disk and compares device serial numbers. If the numbers do not match,
change them by responding to the prompts.
Measuring the
Standard and
Displaying the Data
When you are ready to measure the device press {
MEASURE DATA
} and
respond to the prompts on the controller display. The program initializes the
system and gives you instructions about making proper connections.
Measure all of the devices in your kit.
1. Press {
PRINT ALL
} and the program prints out a complete results sheet for
the measurement of the device. If the device fails at any frequency, the
letter F appears in the column along with a failure notice at the bottom
of the sheet.
2. To quit the program press [
PRIOR MENU
] until you can select the softkey.