HP 742n - Pavilion - 512 MB RAM, Owner'S Manual, Page: 23 / 144

upgrading and servicing the pc
19
Filename: ma1rwtc.doc Title: HP-Print2k.dot
Template: HP-Print2K.dot Author: WASSER, Inc. Last Saved By: WASSER, Inc.
Revision #: 161 Page: 19 of 46 Printed: 04/26/01 09:20 AM
English
B
C
7 If you are removing the bottom optical drive,
remove the two screws (
C ) on the drive and
push the drive part way out through the front
of the computer.
Or
If you are removing the top optical drive,
remove the screws (
B and C ) on both optical
drives and push both drives part way out
through the front of the computer. (This allows
better access to the cables at the back of the
drive.)
8 Remove the cables on the back of the drive
you want to replace.
9 Pull the drive out through the front of the
computer.
To install a new optical drive:
Note:
Make sure the jumper on the new drive is in the
CS (Cable Select) position.
1 Slide the new optical drive through the front of
the computer. Don’t slide the drive in all the
way — you need room to attach the cables.
2 Attach the cables to the back of the optical
drive.
3 Push the drive(s) all the way in, aligning the
screw holes.
4 Attach the screws.
To reassemble the computer:
1 Replace the fan duct and side panel (see
“Closing the Computer” on page 21).
2 Reconnect the power cord and all other
cables.
3 Reconnect the modem/phone cable.
4 Turn on the computer and all peripherals.
5 Install any software drivers supplied by the
drive manufacturer.