HP 6400cl, Management Manual, Page: 59 / 664

Static Virtual LANs (VLANs)
Configuring VLANs
Status:
Port-Based : Port-Based, static VLAN
Protocol:
Protocol-Based, static VLAN
Dynamic: Port-Based, temporary VLAN learned through
GVRP (Refer to chapter 3, “GVRP” .)
Voice:
Indicates whether a (port-based) VLAN is configured as
a voice VLAN. Refer to “Voice VLANs” on page 2-49 .
Jumbo: Indicates whether a VLAN is configured for Jumbo
packets. For more on jumbos, refer to the chapter titled “Port
Traffic Controls” in the
Management and Configuration Guide
for your switch.
For example:
When GVRP is disabled
(the default), Dynamic
VLANs do not exist on the
switch and do not appear
in this listing. (Refer to
chapter 3, “GVRP” .)
Figure 2-18. Example of “Show VLAN” Listing (GVRP Enabled)
Displaying the Configuration for a Particular VLAN .
This command
uses the VID to identify and display the data for a specific static or dynamic
VLAN.
Syntax:
show vlans < vlan-id >
802.1Q VLAN ID:
The VLAN identification number, or VID. Refer
to “Terminology” on page 2-5.
Name:
The default or specified name assigned to the VLAN. For
a static VLAN, the default name consists of
VLAN-
x
where “
x
”
matches the VID assigned to that VLAN. For a dynamic VLAN,
the name consists of
GVRP_
x
where “
x
” matches the applicable
VID.
2-29