437
Configuring route related attributes for a VPN instance
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter VPN instance view
or IPv4 VPN view.
•
Enter VPN instance view:
ip vpn-instance
vpn-instance-name
•
Enter IPv4 VPN view:
a.
ip vpn-instance
vpn-instance-name
b.
address-family ipv4
Configurations made in VPN
instance view apply to both IPv4
VPN and IPv6 VPN.
IPv4 VPN prefers the
configurations in IPv4 VPN view
over the configurations in VPN
instance view.
3.
Configure route targets.
vpn-target
vpn-target
&<1-8> [
both
|
export-extcommunity
|
import-extcommunity
]
By default, no route targets are
configured.
4.
Set the maximum
number of active routes
allowed.
routing-table
limit
number
{
warn-threshold
|
simply-alert
}
By default, the maximum number of
active routes in the VPN instance is
not limited.
Setting the maximum number of
active routes for a VPN instance
can prevent the PE from learning
too many routes.
5.
Apply an import routing
policy.
import route-policy
route-policy
By default, all routes matching the
import target attribute are
accepted.
The specified routing policy must
have been created.
For information about routing
policies, see
Layer 3—IP
Routing
Configuration Guide.
6.
Apply an export routing
policy.
export route-policy
route-policy
By default, routes to be advertised
are not filtered.
The specified routing policy must
have been created.
For information about routing
policies, see
Layer 3—IP
Routing
Configuration Guide.
7.
Apply a tunnel policy to
the VPN instance.
tnl-policy
tunnel-policy-name
By default, only one tunnel is
selected (no load balancing) in this
order: LSP tunnel and CRLSP
tunnel.
The specified tunnel policy must
have been created.
For information about tunnel
policies, see "
