329
Tasks at a glance
Remarks
:
•
(Optional.)
•
(Required.) Choose either of the following tasks to configure a PW:
{
{
{
{
Configuring a remote CCC connection
Choose a PW configuration
method depending on the MPLS
L2VPN implementation.
Binding an AC to a cross-connect
For multi-segment PWs, skip this
task.
•
Configuring static PW redundancy
•
Choose either task to configure
PW redundancy.
Enabling MAC address software learning on an interface
This task applies to an SDN
network.
Enabling L2VPN
Before you enable L2VPN, perform the following tasks:
•
Configure an LSR ID for the PE with the
mpls lsr-id
command.
•
Enable MPLS with the
mpls enable
command on the backbone interface of the PE.
To enable L2VPN:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enable L2VPN.
l2vpn enable
By default, L2VPN is disabled.
Configuring an AC
CAUTION:
•
On a PE, if the interface connected to a PW and the interface connected to an AC reside on different IRF
member devices, the default VLAN ID configured on the interface connected to the AC must be different
from the inner VLAN ID of the packets to be forwarded from the PW to the AC.
•
On an interface, Ethernet service instance is mutually exclusive with EVB. For more information about
EVB, see
EVB Configuration Guide.
An AC is an Ethernet service instance on a Layer 2 Ethernet interface or Layer 2 aggregate interface that
connects to a CE.
To configure an Ethernet service instance:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
