551
•
display ipv6 policy-based-route local
Routing policy commands
Common routing policy commands
apply as-path
Use
apply as-path
to set the AS_PATH attribute for BGP routes.
Use
undo apply as-path
to restore the default.
Syntax
apply as-path
as-number
&<1-32>
[
replace
]
undo apply as-path
Default
No AS_PATH attribute is set.
Views
Routing policy node view
Predefined user roles
network-admin
Parameters
as-number
&<1-32>: Specifies an AS by its number in the range of 1 to 4294967295. &<1-32> indicates
that the argument before it can be entered up to 32 times.
replace
: Replaces the original AS numbers. If this keyword is not specified, the command adds the
specified AS numbers before the original AS_PATH attribute.
Examples
# Configure node 10 in
permit
mode for routing policy
policy1
to add AS number 200 before the
original AS_PATH attribute of BGP routes matching AS path list 1.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy-policy1-10] if-match as-path 1
[Sysname-route-policy-policy1-10] apply as-path 200
Related commands
•
display ip as-path
•
if-match as-path
•
ip as-path
apply comm-list delete
Use
apply comm-list delete
to delete the COMMUNITY attributes from BGP routes.
