48
Specify the ports for authentication and accounting as 1812 and 1813 respectively
Select
Device Management Service
as the service type
Select
HP(A-Series)
as the access device type
Select the access device from the device list or manually add the device with the IP address of
10.1.1.2
Click
OK
to finish the operation
NOTE:
The IP address of the access device specified above must be the same as the source IP address of the
RADIUS packets sent from the device, which is the IP address of the outbound interface by default, or
otherwise the IP address specified with the
nas-ip
or
radius nas-ip
command on the device.
Figure 13
Add an access device
# Add a user for device management
Log in to the iMC management platform, select the
User
tab, and select
Device Management User
from
the navigation tree to enter the
Device Management User
page. Then, click
Add
to enter the
Add Device
Management User
window and perform the following configurations as shown in
Add a user named
hello@bbb
and specify the password
Select
SSH
as the service type
Set the EXEC privilege level to 3. This value identifies the privilege level of the SSH user after login
and defaults to 0.
Specify the IP address range of the hosts to be managed as 10.1.1.0 to 10.1.1.255
Click
OK
to finish the operation
