HP 3C590-TPO, Installation Manual, Page: 15 / 44

3 Connecting to a Windows NT Server 3.51
Windows for Workgroups Ver. 3.11
3 Connecting to a Windows NT Server 3.51
Windows for
Workgroups Ver. 3.11
Requirements
• HP Vectra with DOS and MS-Windows for Workgroups 3.11 installed.
• 3COM Etherlink 3C590 PCI ethernet card and drivers disk ver 5.1a.
• Driver Name: El59X.386 Size: 55KB Date: 10/4/96
• Microsoft Windows NT Server 3.51 machine that supports Net BEUI,
NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• Network Driver Optimization Normal
• Full Duplex Disabled
• Boot PROM Disabled
• Media Type 10BASE-T
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink III 3C590
adapter card into a PCI slot.
2 Connect network cable media to the 3COM 3C590 card.
3 Power on machine and allow to boot to MS-DOS.
4 After booting, insert the 3COM’s drivers disk “Etherlink 3C590 PCI
Ethernet ver. 5.1a”, and execute “A:\3C59XCFG.EXE.”
5 Select “CONFIGURE NIC,” and verify the resource settings listed above
under the heading “Device Configuration.”
6 If changes are required, save those changes and exit.
7 Remove the 3COM Drivers diskette and reboot the machine.
Vectra VL8 Vectra VL7 Vectra VE7/VE8
I/O Port Address FCC0h (PCI) FCC0h (PCI) DC00h (PCI)
Interrupt Level 10 (PCI) 9 (PCI) 10 (PCI)