7
POST error messages
This chapter lists the error codes, error messages, and the various indicator light and audible sequences that you
may encounter during Power-On Self-Test (POST) or computer restart, the probable source of the problem, and
steps you can take to resolve the error condition.
POST Message Disabled suppresses most system messages during POST, such as memory count and non-error
text messages. If a POST error occurs, the screen will display the error message. To manually switch to the POST
Messages Enabled mode during POST, press any key (except
F10
,
F11
, or
F12
). The default mode is POST
Message Disabled.
The speed at which the computer loads the operating system and the extent to which it is tested are determined
by the POST mode selection.
Quick Boot is a fast startup process that does not run all of the system level tests, such as the memory test. Full
Boot runs all of the ROM-based system tests and takes longer to complete.
Full Boot may also be enabled to run every 1 to 30 days on a regularly scheduled basis. To establish the
schedule, reconfigure the computer to the Full Boot Every x Days mode, using Computer Setup.
NOTE:
For more information on Computer Setup, see
Computer Setup (F10) Utility on page 56
.
POST numeric codes and text messages
This section covers those POST errors that have numeric codes associated with them. The section also includes
some text messages that might be encountered during POST.
NOTE:
The computer will beep once after a POST text message is displayed on the screen.
Control panel message
Description
Recommended action
101-Option ROM Checksum Error
System ROM or expansion board option ROM
checksum.
1.
Verify the correct ROM.
2.
Flash the ROM if needed.
3.
If an expansion board was recently added,
remove it to see if the problem remains.
4.
Clear CMOS (see
).
5.
If the message disappears, there might
be a problem with the expansion card.
6.
Replace the system board.
103-System Board Failure
DMA or timers.
1.
Clear CMOS. (see
.)
2.
Replace the system board.
162-System Options Not Set
Configuration incorrect.
RTC (real-time clock) battery may need to
be replaced.
Run Computer Setup and check the configuration
in Advanced > Onboard Devices.
Reset the date and time under Control Panel. If
the problem persists, replace the RTC battery.
See the Removal and Replacement section for
instructions on installing a new battery, or
70
Chapter 7 POST error messages
