17
2)
Lift the P2, P3, P4, P5 (VA) & P1, P2 (RA) connector from the PCB.
3)
Place the new component on the PCB. Be sure that it matches the PCB footprint.
4)
Solder the new component.
USB-C connector P1
Repair the HDMI connector:
1)
Use a hot air gun to melt the solder on the pins.
2)
Lift the P1 connector from the PCB.
3)
Place the new component on the PCB. Be sure that it matches the PCB footprint.
4)
Solder the new component.
Headphone connector CN2
Repair the Headphone connector:
1)
Use a hot air gun to heat the bottom side of PCB below the headphone connector.
Remove USB connectors
Remove USB connectors
Remove USB-C connector
