HP 170X - JetDirect Print Server, Installation And Configuration Manual

Page: 62 / 80

56 CHAPTER 7: HP JETDIRECT CONFIGURATION PAGE MESSAGES
TFTP REMOTE
ERROR
The TFTP transfer of the configuration file from
the host to the HP JetDirect print server failed
with the remote host sending a TFTP ERROR
packet to the print server.
TFTP RETRIES
EXCEEDED
The overall retrying of the TFTP transfer of the
configuration file from the host to the
HP JetDirect print server has exceeded a retry
limit.
TOTAL PACKETS
RECEIVED:
TOTAL PACKETS
RCVD:
Total number of frames (packets) received by
the HP JetDirect print server without error. This
includes broadcast, multicast packets, and
packets specifically addressed to the print
server. This number does not include packets
specifically addressed to other nodes.
TRANSMIT
ERROR
Check the network topology and verify all
cable segments.
TRYING TO
CONNECT TO
SERVER
The HP JetDirect print server is trying to
connect to the print server or NetWare file
server after being configured. Wait for the
print server to establish a connection with the
print or file server.
TURN PRINTER
OFF/ON
This message may appear after you upgrade to
a new version of firmware. When this message
appears, turn the printer off, then back on to
enable any new functionality that was recently
downloaded.
Table 7-2 General HP JetDirect Messages
Message
Description
UNABLE TO
ATTACH TO
QUEUE
A failure was detected when the HP JetDirect
print server tried to attach to one of the
queues assigned to the print server object. This
may be because no servers are allowed to
attach to this queue. There may also be a
networking or security problem. Use
PCONSOLE to make sure that servers are
allowed to attach to the queue, to delete the
print server object from the list of queue
servers if you want the HP JetDirect print server
to service other queues, or to delete the queue
and create a new one (the print server object
must be added to the list of queue servers).
When the HP JetDirect print server is
configured for multiple file servers, the error is
only displayed on the configuration page if
none of the file servers made the connection.
Table 7-2 General HP JetDirect Messages
Message
Description