HP 170X - JetDirect Print Server, Installation And Configuration Manual

Page: 53 / 80

General HP JetDirect Messages 47
General HP JetDirect Messages
Table 7-2 General HP JetDirect Messages
Message
Description
ARP DUPLICATE
IP ADDRESS
The ARP layer has detected another node on
the network using the same IP address as the
HP JetDirect print server. Extended error
information below this message shows the
hardware address of the other node.
BABBLE ERROR Run the power-on self-test: turn the printer
off, then on again. If the error persists, call the
HP‘s Customer Care In-Country Numbers (see
Chapter 1 for telephone numbers).
BAD BOOTP
REPLY
An error was detected in the BOOTP reply that
the HP JetDirect print server received. The
BOOTP reply either had insufficient data in the
UDP datagram to contain the minimum BOOTP
header of 236 bytes, had an operation field
that was not BOOTPREPLY(0X02), had a header
field that did not match the print servers
hardware address, or had a UDP source port
that was not the BOOTP server port (67/udp).
BAD BOOTP TAG
SIZE
The tagsize in a vendor specific field in the
BOOTP reply is either 0, or greater than the
remaining number of unprocessed bytes in the
vendor specified area.
BAD LENGTH
RCVD:
Total number of frames missed because they
were too long for the HP JetDirect print server
to receive.
BAD PACKETS
RCVD:
Total number of frames (packets) received by
the HP JetDirect print server with errors.
BOOTP IN
PROGRESS
The HP JetDirect print server is currently in the
process of obtaining its basic IP configuration
information through BOOTP, and has not
detected any errors.
CF ERR - ACCESS
LIST EXCEEDED
The TFTP configuration file specified too many
access list entries using the “allow:” keyword.
CF ERR - FILE
INCOMPLETE
The TFTP configuration file contained an
incomplete last line that did not end in a
newline character.
CF ERR - INVALID
PARAM
A line in the TFTP configuration file contained
an invalid value for one of the parameters on
that line.
CF ERR - LINE
TOO LONG
A line being processed in the TFTP
configuration file was longer than the
HP JetDirect print server could accept.
CF ERR -
MISSING PARAM
A line in the TFTP configuration file was
missing a required parameter.
Table 7-2 General HP JetDirect Messages
Message
Description