HP 170X - JetDirect Print Server, Installation And Configuration Manual

Page: 45 / 80

Resetting Configuration to Factory Defaults 39
Resetting Configuration to Factory Defaults
Once you configure your print server, the
configuration settings are retained in memory unless
you manually reset them to factory defaults.
To reset the print server to factory defaults, follow
these steps:
1
Unplug the power cord from the print server.
2
While holding down the Test button on the print
server, plug the power module into the print server
and continue to hold down the
Test
button for five
seconds. Any user-configured settings will be erased.
Troubleshooting Steps
Follow these overall steps to diagnose and resolve the
problem:
■
Verify the printer works properly.
■
Verify the print server hardware works properly.
■
Verify that you can print to the printer when it‘s
attached directly to a PC.
■
Verify that the HP JetAdmin software is installed
and runs properly.
I. Verify the printer works properly
■
Print a printer self-test page to make sure the
printer works properly.
■
See your printer documentation to interpret the
printer self-test page, and to diagnose and correct
printer problems.