HP 14-BS0 Series, Maintenance And Service Manual

Page: 59 / 112

Solid-state drive (SSD)
Description Spare part number
512 GB solid-state drive 763008-015
256 GB solid-state drive 865902-011
128 GB solid-state drive 827560-040
Mylar for use with solid-state drives 930980-001
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see Battery on page 32 ).
5. Remove the optical drive (see Optical drive on page 34 ), if installed.
6. Remove the bottom cover (see Bottom cover on page 41 ).
Remove the solid-state drive:
1. Remove the Phillips PM2.0×2.0 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE: Solid-state drives are designed with notches to prevent incorrect insertion.
Reverse this procedure to reassemble and install the solid-state drive.
Component replacement procedures 51