319
Step Command
Remarks
4.
Specify an authentication
method for the IKE
proposal.
authentication-method
{
dsa-signature
|
pre-share
|
rsa-signature
}
By default, an IKE proposal
uses the pre-shared key
authentication method.
5.
Specify an authentication
algorithm for the IKE
proposal.
•
In non-FIPS mode:
authentication-algorithm
{
md5
|
sha
|
sha256
|
sha384
|
sha512
}
•
In FIPS mode:
authentication-algorithm
{
sha
|
sha256
|
sha384
|
sha512
}
By default, an IKE proposal
uses the HMAC-SHA1
authentication algorithm.
6.
Specify a DH group for key
negotiation in phase 1.
•
In non-FIPS mode:
dh
{
group1
|
group14
|
group2
|
group24
|
group5
}
•
In FIPS mode:
dh
{
group14
|
group24
}
By default:
•
In non-FIPS mode, DH
group1 (the 768-bit DH
group) is used.
•
In FIPS mode, DH group14
(the 2048-bit DH group) is
used.
7.
Set the IKE SA lifetime for
the IKE proposal.
sa
duration
seconds
By default, the IKE SA lifetime is
86400 seconds.
Configuring an IKE keychain
Perform this task when you configure the IKE to use the pre-shared key for authentication.
Follow these guidelines when you configure an IKE keychain:
1.
Two peers must be configured with the same pre-shared key to pass pre-shared key
authentication.
2.
You can specify the local address configured in IPsec policy or IPsec policy template view
(using the
local-address
command) for the IKE keychain to be applied. If no local address is
configured, specify the IP address of the interface to which the IPsec policy is applied.
3.
You can specify a priority number for the IKE keychain. To determine the priority of an IKE
keychain:
a.
The device examines the existence of the
match local address
command. An IKE
keychain with the
match local address
command configured has a higher priority.
b.
If a tie exists, the device compares the priority numbers. An IKE keychain with a smaller
priority number has a higher priority.
c.
If a tie still exists, the device prefers an IKE keychain configured earlier.
To configure the IKE keychain:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create an IKE keychain
and enter its view.
ike keychain
keychain-name
[
vpn-instance
vpn-name
]
By default, no IKE keychain
exists.
Summary of Contents for 10500 series
Page 326: ...312 No duration limit for this SA ...
