Hardware options installation
Introduction
If more than one option is being installed, read the installation instructions for all the hardware options and
identify similar steps to streamline the installation process.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION:
To prevent damage to electrical components, take the appropriate anti-static precautions before
beginning any installation, removal, or replacement procedure. Improper grounding can cause
electrostatic discharge.
Installing a security bezel option
The security bezel helps prevent unauthorized physical access to the front panel components. Install the
security bezel and then lock it with the key provided with the kit. The security bezel is only supported in
servers that are using the quick-release latch rack ears.
1
2
3
4
Drive options
The server supports up to two LFF hot-plug or non hot-plug drives and four SFF hot-plug.
The embedded storage controller supports SATA drive installation.
For SAS drive installation, install a Host Bus Adapter or a Smart Array Controller board option. For more
information about product features, specifications, options, configurations, and compatibility, see the product
QuickSpecs on the
Hewlett Packard Enterprise website
Drive installation guidelines
When adding drives to the server, observe the following general guidelines:
38
Hardware options installation