INSTALLATION
BOARD
WALL
FILM
COMPUTER GPU
USB DEVICES
PROJECTORS
(HDMI)
BOARD
PEN
*EDGE-BLENDING ONLY
BOARD
CLEATS
ANGLED
DOWN
WALL
CLEATS
ANGLED
UP
BOARD
FILM
WEBCAM
BOARD
Measure, mark, and install your projector(s)
in relation to where the Boards will be
placed.
Measure and mark the placement of the
Wall Cleats.
Install the Wall Cleats - Board Cleats are
angled
DOWN
while Wall Cleats are angled
UP
. (See next)
Hang Boards and u
se Biscuits to join the
Boards. TIP: Soak biscuits in warm water for
2-3 minutes to make them more pliable.
Clean Boards to make sure no dust is
present before applying Film.
Roll Film directly onto the board. Have a
buddy help you keep the film steady.
After applying the Film, cut the Dot Pattern
material to fit the Boards. Use a vinyl cutter.
Be exact.
Mount the webcam so that it has a clear,
unobstructed view of the HoyluWall™.
Connect your PC to all devices- Bluetooth
Dongle (USB), Projectors (HDMI), and
optional Edge-Blending Camera (USB).
Set up and connect your Hoylu Pens.
(page 8)
Calibrate Dot Pattern via Hoylu Central.
Calibrate Dot Pattern via Hoylu Central
*Edge-Blending: Configure (page 8)
VINYL CUTTER
Start Collaborating!
*Refer to your
Projector’s Manual
5
Summary of Contents for HoyluWall
Page 1: ...WALL INSTALLATION MANUAL...