Page 11
Hotsy 1065A/1065SS
IMPORTANT
If the pressure washer demonstrates other symptoms or the corrective actions
listed do not correct the problem, contact the local authorized Hotsy Service
Center. The Hotsy Service Center can be identified by contacting:
Customer Service Department
The Hotsy Corporation
21 Inverness Way East • Englewood, Colorado 80112
(303) 792-5200
TROUBLESHOOTING GUIDE
SYMPTOM
POSSIBLE CAUSES
CORRECTIVE ACTION
Pressure washer will not
produce hot water.
...continued
Thermostat set too low.
Adjust thermostat to desired temp-
erature.
Blown fuse.
Replace. Fuse is located in Control
Box.
Engine is running too slow.
Move throttle lever to full throttle
position.
Battery charge is low.
Charge battery or replace if necessary.
Poor or no detergent
flow.
Inadequate detergent supply.
Refill detergent container. Ensure that
pick-up screen is fully immersed. Open
detergent valve.
Detergent screen or hose clogged.
Clean. Always start with a clean deter-
gent container.
Detergent injector valve not set
correctly.
Refer to To Clean for settings.
Clogged detergent injector check
valve.
Clean check valve at detergent injector
inlet.
Poor cleaning.
Improper detergent concentration or
mixing.
Mix detergent per manufacturer's
instructions. Ensure that powdered
detergents are fully dissolved.
Wrong detergent for the application.
Select appropriate detergent.
Rinsing with hot water.
A final rinse with cold water will reduce
water spotting.
