42
FOOT WARMER XLP ONE
Installing Heating Elements XLP
If using Hotronic’s ONE SIZE FITS ALL INSOLES in footwear without removable insoles:
1)
Trace outline of foot on backside of Insole with TOES aligned over top of Heating Element.
2)
Cut Insole along sides and heel.
3)
Select slightly larger sizing line at first.
4)
Further trim Insole where necessary.
6.2 Installing Heating Elements XLP on custom insoles
Variant 1
(see Figs 24 through 28)
1)
With foot on custom insole, position Heating Element under toes placing Power Cord toward
heel. (Fig. 21)
2)
Remove foot, carefully lift Heating Element slightly, and mark position on insole where Power
Cord connects to Element.
3)
Use razor knife or grinding device to make slit or narrow opening at marked position. Hard
insole material may require wider opening for 3 snap connector. Use heat gun to soften hard
material for narrowest opening. (Fig. 24)
4)
Run Power Cord through slit or opening until Element lies flat and in correct position. (Fig. 25)
5)
Remove adhesive cover layer on bottom of Element and adhere Element in correct position.
If Element is without self-adhesive layer, use spray or brush-on adhesive between insole and
Element.
6)
Apply self-adhesive fabric cover over top of insole. Trim excess with scissors AFTER
applying. If needed, use additional adhesive between insole and fabric. (Fig. 26 and 27)
7)
Apply self-adhesive fabric strip over Power Cord on bottom of insole to hold in place. (Fig. 28
)
Variant 2
See Figs 29 through 32 for instructions on installing Heating Elements XLP on custom insoles
Variant 2.
6.3 Installing insoles with Heating Elements XLP in general footwear
1)
Place insole in footwear.
2)
Run Power Cord up back or side of leg.
3)
Securely fasten Battery Pack as per instructions.
4)
Connect 3 snap connector of Heating Element onto Battery Pack.
6.4 Installing insoles with Heating Elements XLP in boots with
removable liners
1)
Pay complete attention during installation to prevent chafing, abrading, cutting, over tension,
and tearing of Power Cord. These types of damages are NOT covered under Manufacturer’s
Limited Warranty. (Fig. 40-46)
2)
To place Power Cord between inner boot (removable liner) and shell, Hotronic recommends
following:
Remove inner boot from shell and existing insole from inner boot.
Summary of Contents for XLP ONE
Page 1: ......
Page 2: ......
Page 108: ...108 FOOT WARMER XLP ONE a Fig 42 43 4 Fig 44 45 5 Fig 46 7 1 Hotronic 2 1 3...
Page 110: ......
