FITTING AND OPERATING INSTRUCTIONS
DOMINO 1100 RC
DOMINO 1XXX, other versions
Radar motion sensors for the detection of objects for automatic gates.
SAFETY INFORMATION
The unit is only to be operated with voltages that comply with the
Safety Extra-Low Voltage (SELV) requirements in safety
standards based on IEC 60950. This unit is only to be installed
and maintained by trained, qualified personnel.
1. FITTING
1.1
OPENING THE RADAR SENSOR UNIT
1.2 DRILLING
from the rear, prior to installation
from the front, after installation
Stick the drilling template in place and drill
according to the instructions
1.3
FASTENING AND CONNECTING-UP
Draw the cable through the opening provided
Connect the cable to the terminals
1 power supply AC/DC brown
2 power supply AC/DC green
3 Main relay
white
4 Main relay
yellow
Vehicle relay
grey
Vehicle relay
pink
Fasten the base plate with the screws contained in the housing,
to remove and insert the electronics, observe the instructions in point 2.3
1.4
OTHER INSTALLATION OPTIONS
Optional accessory out of the 4tec accessory range.
Ceiling-mounting with mounting bracket
or
Wall fastening with weather-cap set
