and
(continued)
Plug-In Units
CAUTION
●
Do not attempt to clean plug-in
surface units in an
dishwasher.
●
Do not immerse plug-in surface
units in liquids of any kind.
Plug-in units can be removed.
●
Do not bend the plug-in surface
unit plug terminals.
●
Do not attempt to clean, adjust or
in any way repair the plug-in
receptacle.
Adjusting Oven
Lift a plug-in unit about 1“ above
Thermostat
the
enough to grasp
it—and you can pull it out.
The temperature control in your
new oven has been carefully
adjusted to provide accurate
temperatures. However, if this
oven has replaced one you have
used for several years, you may
Do not lift a
more
than
l“. If you do, it may not lie
flat on the drip pan when you
plug it back in.
Repeated lifting of the plug-in
unit more than 1“ above the drip
pan can permanently damage
the receptacle.
To replace a plug-in unit:
●
The drip pan must be placed into
the surface cavity first. Make sure
the opening in the drip pan lines up
with the receptacle.
●
Insert the terminals
the plug-in
unit through the opening in the
drip pan and into the receptacle.
●
Guide the surface unit into place
so it fits evenly in the drip pan.
notice a difference in the degree of
browning or the length of time
required when using your favorite
recipes because oven temperature
controls have a tendency to “drift”
over a period of years.
Before attempting to have the
1. Pull the knob off the
look at the back side. There is a
disc in the center of the knob skirt
with a series
marks opposite
a pointer.
Note to which mark the pointer is
pointing. To make an adjustment,
carefully loosen (approximately
one turn), but do not completely
remove the two screws that
the skirt to the knob. Hold the
knob blade in one hand and the
outer skirt in the other hand.
2. To raise the oven temperature,
move the pointer in the direction
of the arrow for RAISE. To lower
the temperature, move the pointer
in the direction of the arrow for
LOWER. Each mark will change
the oven temperature approximately
We suggest that you make
the adjustment one mark
the
original setting and check oven
performance before making any
additional adjustments.
3. After the adjustment is made,
press skirt and knob together and
screws so they are snug,
but be careful not to
temperature of
new oven
Reinstall knob on range
changed, be sure you have
check performance. Be sure to
followed the baking time and
match “D” shaft on knob to stem
temperature of the recipe carefully.
when
after you have
the oven
.
NOTE: After an adjustment has
a few times and you feel the oven
is too hot or too cool, there is a
simple adjustment you can
make yourself on the OVEN
knob.
Note position of
pointer to marks
before adjustment
Loosen only
. the locking
screws
been made to the OVEN
knob, OFF and BROIL will not
line up with the indicator mark on
the control panel as they previously
did. This condition is
and
will not create a problem.
22