Removable Oven Door
To REMOVE door, open to BROIL
position, or where you feel hinge
catch slightly. Grasp door at sides;
lift door up and away from hinges.
To REPLACE, grasp door at sides.
Line up door with hinges and push
door firmly into place.
Outer
Enamel Finish
(on models so equipped)
The porcelain enamel cooktop is
sturdy but breakable if misused.
This finish is acid-resistant.
However, any acid foods spilled
(such fruit juices, tomato or
vinegar)
not be permitted to
remain on the finish.
Lift-Up Cooktop
Clean the area under the cooktop
often. Built-up soil, especially
grease,
catch fire.
make
easier, the entire
cooktop may be
up and
supported by the support rod that
catches
holds the top when it’s
the way up.
Be sure all surface units are
turned off before raising the
cooktop. Grasp the front sides of
the cooktop and lift.
After cleaning under the cooktop
with hot, mild soapy water and a
cloth, put the cooktop back
in place. Be careful not to pinch
your fingers.
Brushed Chrome Finish
(on models so equipped)
Clean the brushed chrome top with
warm, soapy water or an all-purpose
household cleaner and immediately
dry it with a clean, soft cloth. Take
care to dry the surface following the
“grain.” To help prevent finger
marks after cleaning, spread a thin
of baby oil on the surface. Wipe
away excess oil with a clean, soft
cloth. A good appliance
will
help protect this finish.
Oven Light Bulb
The light bulb is located on the rear
wall of the oven. Before replacing
the bulb, disconnect electric power
to the range at the main fuse or
circuit breaker panel or unplug the
range from the electric outlet. Let
the bulb cool completely before
removing it. Do not touch a hot
bulb with a damp cloth. If you do,
the bulb will break.
Never touch the electrically live
collar on the bulb when replacing it.
To remove:
●
Unscrew and lift off the glass
cover. Remove the bulb.
To replace:
●
Put in a new 40-watt appliance
bulb.
NOTE: A 40-watt appliance bulb
is smaller than a standard 40-watt
household bulb. We recommend
you use an appliance bulb that is
no
than
●
Replace and tighten the cover.
●
Reconnect electrical power to the
range.
DO NOT REMOVE SCREWS.
Surface Units
Clean the area under the drip pans
often. Built-up soil, especially
grease, may catch fire. To make
cleaning easier, plug-in units are
removable.
Caution: Be sure
all controls are
turned to OFF and surface units
are cool before attempting to
remove them.
After removing plug-in units,
remove the drip pans under the units
and clean them according to
directions in the Cleaning Guide.
Wipe around the edges of the
surface unit openings. Clean the area
below the units. Rinse all washed
areas with a damp cloth or sponge.
Control Knobs
The control knobs may be removed
for cleaning.
To remove knob, pull it straight off
the stem. If knob is difficult to
remove, place a thin cloth (like a
handkerchief or a piece of string
under and around the knob edge and
pull up.
Wash knobs in soap and water but
do not soak.
To replace knob, locate the groove
in each side of the knob stem. One
of the grooves contains a spring
clip and the other groove is clear.
Locate the molded rib inside the
knob. Fit the molded rib of the
knob into the clear groove on the
knob
Make sure to replace the single
oven control knob on the correct
knob stem.
21