Remove the door
1.
Lay down the appliance on its back.
2. Unscrew, remove
and retain both
front
feet.
3. Unscrew and
remove the right
hand bottom hinge
plate and (spacing
washers if fitted).
Reposition the hinge pin into
the other hole on the metal bracket.
4.
Slightly open the door, slide downwards,
remove and carefully place to one side.
5.
Unscrew the hinge pin from the top right
hand hinge plate and refit on the
opposite side.
6. Use a thin blunt
instrument to remove
the top and bottom
hinge bushes and
blanking plug from the
door (take care
not to mark the door
handle). Reposition
on the opposite side.
Replace the door
1.
Slide the door upwards and locate the
top hinge pin into the door bush.
2.
Fit the bottom hinge with the (spacing
washers if fitted) into the bottom hinge
bush, making sure that the door is
aligned to the cabinet.
3.
Use the fixing screws to secure the
bottom hinge to the cabinet.
4.
Replace the adjustable feet, allowing
25mm from the bottom of the cabinet to
the base of the foot.
5.
Carefully stand the appliance upright in
its required location and make sure it is
sitting level on the floor. Open and close
the door checking that the gasket makes
a good seal without any gaps when the
door is closed.
Note: Replace loose items/fittings back into
the appliance and leave for at least 15
minutes before switching back on.
Door reversal
13
Warning: Before attempting to remove the door, switch off the electrical supply and pull
out the mains plug.
It is recommended that you remove any loose items/fittings from inside the appliance and
place food into insulated containers whilst carrying out this operation.
You may require assistance to carefully lay the appliance onto its back onto suitable protective
materials (i.e. original packaging).
