30
GB
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Before contacting your nearest Service Centre/Installer, check the problem guide below; there may be nothing
wrong with your cooker.
Problem
Check
Slight odour or
small amount of
smoke when grill
/ oven used for
first time
This is normal and should cease after a short period.
Nothing works
If you find that the timer display is blank, then it is likely that there is no electricity supply to
your oven. Check:
(i) That the main cooker wall is switched on
(ii) Other appliances, to see if you have had a power cut
(iii) The main circuit breaker for the property
Top oven, grill
and main oven do
not work.
Operating the cooker under the following conditions may cause a safety device to operate:
(a) Grilling with the door closed - Always grill with the door fully open
(b) Grilling for an excessively long period at maximum setting - see Grilling guide.
Switch off appliance and allow to cool for approx 30 mins.
Switch the cooker back on and check that the Grill / Top oven is now operating.
Grill keeps tur-
ning on and off
When the Grill control is operating at less than its maximum setting, the Grill will cycle on
and off, this is normal and not a fault.
Timer Display is
flashing ‚
0.00
‚
The power supply to your oven has possibly been interrupted, but has now come back on
again. Reset the timer to the correct time and „Manual” operation using the instructions
given in the timer section of the book.
Oven tempera-
tures too high
or low
Check temperature and shelf positions are as recommended in the Oven Temperature
Charts.
It may be necessary to increase or decrease the recommended temperature slightly to suit
your taste.
Oven does not
cook evenly
Check:
(a) Temperature and shelf positions are as recommended in the Oven Temperature
Charts.
(b) Oven utensils being used allow sufficient air flow around them.
The oven is not
working and
showing F01 to
F68 code in the
display
Your appliance has developed a fault which will require assistance from our service depart-
ment.
Oven light does
not work
The oven lamp is not covered by the guarantee. The part is easily changed (see the sec-
tion on oven lamp replacement). A new lamp may be obtained from our Parts department
see back page.
Draught from
beneath control
panel
A gentle flow of air will be blown from beneath the control panel when the appliance is
used. If the appliance is still warm, this cooling fan may run on, or restart itself when all
controls have been turned off. The fan will stop once the appliance has been cooled. This
is normal and not a fault.
Steam / Conden-
sation in the oven
after use.
Steam is a by - product of cooking any food with a high water content. To help minimise
always:
a) Try to avoid leaving food in the oven to cool after being cooked.
b) Use a covered container, wherever possible.
If you have been through the above list and there is still a problem, contact Service (see back page).
