Hospira LifeCare XL Series, Technical & Service Manual

Page: 103 / 278

SECTION 7 REPLACEABLE PARTS AND REPAIRS
430-00587-008 (Rev. 2/05) 7 - 24 Plum XL Series
1. Separate the front enclosure assembly and rear enclosure assembly as described
in Section 7.2.5 .
2. Remove the power supply PWA as described in Section 7.2.8.2 .
3. Carefully lift the EMI shield.
4. Using the 10mm nutdriver, remove the two nuts from the equipotential post.
5. Remove the DataPort/ground cable from the equipotential post. If the ground cable
is damaged, use the 1/4 nutdriver to disconnect the other end by removing the
4-40 self locking nut from the DataPort bracket. Replace the ground cable.
6. Remove the EMI shield and replace if necessary.
7. Using the 3/16 nutdriver, remove the two 4-40 lock screws securing the AC
receptacle to the rear enclosure.
8. Using the 10mm wrench, remove the equipotential post. Remove the AC receptacle
bracket. Inspect both for damage, and replace if necessary.
9. Remove the AC receptacle housing seal, inspect for damage and replace if necessary.
10. Remove the AC receptacle gasket, inspect for damage and replace if necessary.
11. Remove the AC receptacle by pulling it away from the rear enclosure.
12. Install the replacement AC receptacle.
13. Reassemble the device in the exact reverse order of disassembly.

Note: (XLM with DataPort) When joining the front and rear enclosures, do not
pinch the DataPort/MCU cable between the two enclosures.
14. Connect the infusion system to AC (mains) power.
To verify successful AC receptacle, bracket, gasket, seal and equipotential post
replacement, perform the PVT in
Section 5.2 .
Figure 7-11. AC Power Cord (220 VAC - Plum XLM)
POWER
SUPPLY
PWA
AC RECEPTACLE
BRACKET
REAR ENCLOSURE
AC RECEPTACLE
AC RECEPTACLE
GASKET
AC RECEPTACLE
HOUSING SEAL
4-40 LOCK SCREW
CONNECTOR (2)
EQUIPOTENTIAL
POST
HEX NUT (2)
EMI
SHIELD
04K01043
DATAPORT/GROUND
CABLE ASSEMBLY
FLAT WASHER
LOCK WASHER
EN-2