Hospira GemStar Series, System Operating Manual

Page: 170 / 221

Hospira GemStar System Operating Manual 161
Chapter 14. Operation Test
LED Test
1
Verify that both the Power (green) and Alarm (red) LEDs are lit. Refer to GemStar
Pump Layout on page 2 for the location of the LEDs.
2
Enter the results:
•
If both LEDs are lit, press [
YES/ENTER
].
• If either of the LEDs does not light, press [
NO
].
3
Ensure slide clamp is open prior to inserting cassette.
Volume Accuracy Test
The pump should deliver between 19.0 to 21.0 mL within approximately 3 minutes to
pass this test.
1
Ensure slide clamp is open prior to inserting cassette.
2
Load a primed pump set into the pump. Press .
3
Place the proximal end in the reservoir of water. Press .
4
Place the distal end in a 20+ mL graduated cylinder. Press .
5
Press [
START
].
6
Enter the results:
•
If the pump delivers between 19.0 to 21.0 mL, press [
YES/ENTER
].
• If the pump does not deliver between 19.0 to 21.0 mL, press [
NO
].
f
Tip: Use two microbore pump sets to save time during the next four tests. The first
set should be fully primed BEFORE beginning the volume accuracy test. Use a
second, DRY set for the air-in-line test.
When the proximal occlusion test is complete, remove the WET set from the pump
and insert the DRY set. Press [ START ] to begin the air-in-line test. The WET set can
then be placed in the next unit ready for testing.