Hospira GemStar Series, System Operating Manual

Page: 12 / 221

Hospira GemStar System Operating Manual 3
Chapter 1. Introduction
1
DISPLAY
• Displays the pump’s status.
2
• Silences an alarm.
• This silences an alert for five minutes and an alarm for two minutes.
3 • Stops infusion.
4 • Starts infusion.
5 • Lights continuously when the pump is powered by AC mains.
• Flashes when the pump is powered by external batteries (e.g., battery pack). Not
lit when using disposable AA batteries.
6 • Powers the pump on or off. To power-off the pump, press and hold until the display
clears.
7 • Returns to previous steps during programming.
• Exits Help, Change, and Options menus.
8
• Displays the following menu items from the
STOP
or
RUN
mode*:
New Container Change Program (or Titrate VTBI)
New Program Piggybacking
• Resets a numeric value to zero.
9
• Displays the following Options Menu items from the
STOP
or
RUN
mode*:
1 Review Program 4 Pump Settings 7 Speed Protocol
2 Histories 5 Set Clock 8 Next Dose
3 Keypad Lock 6 Print
• Scrolls through program review and help messages.
• Toggles between AM and PM in time-based entries.
• DOWN arrow toggles between units of measure when entering concentrations.
10 • Toggles between AM and PM in time-based entries.
• UP arrow enters a decimal point in numeric entries.
• Scrolls back by one screen in program review.
11 • Responds “YES” to display questions.
• Accepts entries and goes to the next step.
12 • Responds “NO” to display questions.
13 • Displays information during programming steps and alarm conditions.
• Displays Shift Totals, except during programming steps and alarm conditions.
14
• Clears an
AIR-IN-LINE
alarm.
• Primes a GemStar Pump Set.
15 [
0
] - [
9
] • Selects menu items and enters numeric values. If two numbers appear before a
menu item (e.g., 02), press both number keys to select that item.
* Not all menu items are available with all modes.